Starting Point System : Forum

You are not logged in.

#1 2010-05-17 23:27:45

femtophysiker
New member

General information

Hello Everybody,

I would like to know a thing.

There are two DC analog output channels +5r and +5b, they have a constant 5V dc. Is it possible to generate analog (variable, e.g. 0 to 5V) with somehow changing voltage or depending upon some input variables such as in PID (Proportional Integral Derivative) controller...just a feedback system.


Please check the youtube clip http://www.youtube.com/watch?v=YnFlpxKVMTQ
especially after 5:50 which is my point to generate voltage.

I am using LabVIEW and this little ÁChameleon, communication is by NI-VISA. The NI-DAQ does'nt recognize this card.

Thanks for your information.

FP

Offline

 

Board footer

Powered by FluxBB

Home